查成语>英语词典>wall plug翻译和用法

wall plug

英 [ˈwɔːl plʌɡ]

美 [ˈwɔːl plʌɡ]

墙上插座

英英释义

noun

双语例句

  • Analysis on Tube Wall Thickness Accuracy Improvement Resulting from Modified Second-Piercing Mill of Φ 400mm Plug Pipe Plant
    Φ400mm机组二次穿孔机改造后钢管壁厚精度分析
  • The results show: at lower pressure ratio, heat transfer condition on the plug surface is the worst, peak values of pressure and temperature appear along the wall of plug nozzle, temperature and temperature gradient along the section of wall reach the highest.
    计算结果表明塞式喷管发动机在较低压比的工况下工作时,塞锥受热状况较为恶劣,塞锥壁面出现压强和温度的峰值,该截面内部的温度和温度梯度达到最大。
  • Wall shear stress method integrates the plug flow displacing, the low speed displacing and the turbulent flow displacing methods in theory.
    壁面剪应力设计方法,从理论上把塞流顶替、低速顶替及紊流顶替技术统一起来。
  • It includes a uniquely designed wall socket and plug ( as well as socket adaptors for most traditional plugs used the world over).
    这个系统包括设计独特的壁上插座和插头(还包括适用于世界上大部分传统插头的转向插座)。
  • It is described in this paper how to get an adequate geometry of the piercing plug, including the taper length, nose thickness and the plug wall thickness, when conducting design of the said plug.
    前言:介绍了在顶头设计中,如何正确选择穿孔锥长、鼻端厚及顶头壁厚的几何尺寸。
  • The wire snapped at the wall plug and the light fused
    墙上插座的电线短路烧断了保险丝,电灯跟着灭了。
  • Have to have their own independent wall plug.
    必须要有自己独立的墙上插座。
  • Water plug was introduced and TTAB on the capillary inner wall could be dissolved into the water plug, which enhanced negative zeta potential of the capillary section.
    再以高差法引入水塞,吸附于毛细管壁的TTAB溶解到水中,使该段毛细管的zeta电势变负;
  • Linear deformation zone of generating wall can be obtained by means of non-linear cone angle plug combined with the barrel-shaped rolls, so the wall accuracy can be increased greatly.
    采用带有非线性顶头锥角的顶头与桶形辊相配合可以获得线性的成壁变形区,从而大大提高壁厚精度。
  • The experiment shows the wall shear stress and the Sherwood number follows an analogous law. Their minimum appears at the nose of gas plug, while their maximum appears at the bottom of gas plug.
    实验结果说明,壁面剪应力与Sherwood数的变化规律类似,在弹状泡顶部达到最小。